Ubisys G1, Инструкции по сборке и пусконаладке

Страница: 16 / 51

16 Gateway G1
Section 3 | Gateway G1 Configuration
Figure 12
Caution: In case you contact the ubisys support, these information can be very helpful for our employees.
Here, you also find the Ethernet MAC address (EUI-48), which allows you, for example, to instruct a DHCP
sever to always give the same address.
3.1.2 System status
In the “System status” menu, all status, warning and error messages are displayed.
Examples:
Figure 13
Figure 14
The following feedback can occur:
Status messages (blue highlighted)
Contant Explanation
Initializing The gateway has recently been booted and is about to be ready.
The ZigBee network is being discovered via gateway, to disco-
ver existing components and to integrate them into your Smart
Home System. This procedure may take a few minutes. At initial operation the gateway will automatically scan your Smart
Home network to allocate installed components. Only after this
procedure you will be able to control these components via app.
ZigBee network discovery via gateway completed. No new
components were found. During the scan of your Smart Home network, no Smart Home
components have been found. In case, that installed components
couldn’t be found due to external parasitic inductions, you have
the option to manually start a network scan via app.
ZigBee network discovery via gateway completed. One (or
more) new component(s) were found. The exact number of registered components during the network
scan will be displayed. In case, that installed components couldn’t
be found due to external parasitic inductions, you have the option
to manually start a network scan via app.
A new component (IEEE address: 00:1F:EE:00:00:00:00:01)
was found and integrated into your Smart Home System. Every Smart Home component found can now be clearly identified
by its IEEE address (EUI-64).