Ubisys G1, Инструкции по сборке и пусконаладке

Страница: 13 / 51

13 Gateway G1
Section 2 | Commissioning
Figure 8
2.4.3 Add components
Once you have both successfully configured your gateway and added a smartphone or tablet as a control unit,
you can start to install components, such as dimmers, power switches, blind controllers etc.
When a component has been connected, and power is turned on again, this component will then automatically
try to log in to an open Smart Home network. For this, you have to open your Smart Home network in order to
add new components.
On the web interface, navigate to “Security”, then head to “Open ZigBee network for new components” and
click “Open” (see figure 9).
Figure 9
Your Smart Home network will now be opened for 2 minutes. During this time, one or more new components can
log in to the network (see figure 10).
Figure 10
In your Smart Home app, go to Configuration -> Basic Configuration -> Components . All new components
should be listed here. Optionally, you can also find these components on the “Status” site of the gateway’s web
interface.
Once all components have logged in to the network, you can close your Smart Home network by clicking “Clo-
se” (see figure 10).
A closed network ensures that no foreign devices get unauthorized access to your ZigBee network.
If you wish to add further components, just repeat the procedure.
Caution: Smart Home components only search for an open network as long as they can successfully log in
to one. After that, even in case of a power breakdown, there will be no new searching attempts. If you want
to add components that have been signed to another network before, you will have to set them to default set-
tings first. More information about how to restore default settings can found in the appropriate component’s
manual (“Factory Reset”).