Adjust the elevation angle:
a. Loosen the six hex head bolts to so that the washers
can spin freely by hand.
b. Tighten or loosen the Elevation Adjustment Bolt to set
the desired tilt.
c. Tighten the six hex head bolts.
Elevation
Adjustment Bolt
Note:
Do NOT make simultaneous adjustments on
the Master and Slave.
2.
Slave
Visually aim the Slave at the Master. To adjust the
Slave’s position, adjust the azimuth and elevation as
described in step 1.
3. Check to see if a link is established. Ensure that the LINK
LED is solidly lit green and the Signal LEDs of the Slave are
displaying signal levels.
www.4Gon.co.uk [email protected] Tel: (0)0330 088 0295 Fax: +44 (0)1245 808299
