Uberhaus MPG-10CRN1-BH9, Руководство пользователя

Страница: 7 / 27

OPERATING INSTRUCTIONS
Operating Instructions
- Press the "MODE" button until the "COOL"
indicator light comes on.
- Press the ADJUST buttons "
" or " " to
select your desired room temperature. The
temperature can be set within a range of
O O O O
17 C-30 C/62 F-86 F.
- Press the "FAN SPEED" button to choose
the fan speed.
- Press the "MODE" button until the "DRY"
indicator light comes on.
COOL operation
DRY operation
- Press the "MODE" button until the
"FAN " indicator light comes on.
- Press the "FAN SPEED" button to
choose the fan speed. The temperature
cannot be adjusted.
- Do not put the duct to window.
FAN peration
TIMER operation
operation depen-
you have
- When the unit is on, first press the
Timer button, the TIMER OFF
indicator light illuminates. It indi-
cates the Auto Stop program is
initiated.
-
- Press or hold the UP or DOWN
button to change the Auto time in
0.5 hour increments, up to 10 hours,
then in 1 hour increments up to 24
hours. The control will count down
the time remaining until start.
- The selected time will register in 5
seconds and the system will autom-
atically revert back to display the
previous temperature setting.
- Turning the unit ON or OFF at any
time or adjusting the timer setting
to 0.0 will cancel the Auto Start/
Stop timer program.
- When a malfunction (E1 or E2)
occurs, the Auto Start/Stop timed
program will also be cancelled.
When the unit is off, first press the
Timer button, the TIMER ON indic-
ator light illuminates. It indicates
the Auto Start program is initiated.
- The air conditioner will control room
temperature automatically to reach the setting
- Under AUTO mode, you can not
select the fan speed.
- Under this mode, you cannot select a fan
speed or adjust the temperature.
- Keep windows and doors closed for the
best dehumidifying effect.
- Do not put the duct to window.
E2- Evaporator temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E4- Display panel communication error-
Unplug the unit and plug it back in.
If error repeats, call for service.
P1- Bottom tray is full - Connect the
drain hose and drain the collected
water away. If error repeats, call
for service.
Error codes:
E1-
Room temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
To activate the FOLLOW ME feature,
the indicator light flashes.
9 FOLLOW ME indicator
FOLLOW M E operation
AUTO operation
- When you set the air conditioner in
mode, it will automatically select
heating(in some models only),
This feature can be activated
from the remote control ONLY.
The remote control serves as a
remote thermostat allowing for
the precise temperature control
at its location.
To activate the Follow Me feature,
point the remote control towards
the unit and press the Follow Me
button. The light on the unit control
NOTE: When more than one errors occur,
the priority of the code display order is:
E4--E2--E1--P1.
7
AUTO
cooling,
or fan only
ding on what temperature
selected and the room temperature.