ubbink Robotclean 1, Руководство пользователя

Страница: 6 / 36

7. After the pool has been cleaned, switch OFF the power supply and leave the robot cleaner in the pool for 15-20 minutes after the end of the cleaning cycle. This will allow the
engine to cool properly. Remove the cleaner from the pool.
8. Remove the cleaner from the water at the shallow end of the pool by pulling the cable until the cleaner reaches the water surface. Then lift it out of the water by using the handle,
NOT the cable.
SETTING THE CLEANING PATTERN
Adjusting the cleaner for your pool
The cleaner has two outlets and the direction angle of each outlet is adjustable during running. If the
angle is not satisfying, stop the cleaner, unscrewed the screw as shown in the figure, manually adjust to a proper position (angle dimension: 0 < 1 < 2); after adjusting, tighten the
screws.
Above the default programmed cleaning pattern of your cleaner. Please take into account that each different pool shape requires a different setting.
Note:
the cleaner may stop in the middle of the pool and reverse during cleaning cycle. This is a normal part of the programmed cycle.
ff o -t u h S r u o H 1 = ff o -t u h S r u o H 2 =
1
Robot Clean 1 Operating Instructions and Parts List