UAS CLARCOR SDC Series, Руководство пользователя

Страница: 17 / 24

Revised 10/15
SDC
Shaker Dust Collector
Revised 05/12
SDC
Shaker Dust Collector
Revised 05/12
SDC
Shaker Dust Collector
Check that all hardware is tight, including the
set-screws attaching the hub to the motor shaft, the
shoulder bolt that is threaded into the hub and the nuts
that secure the drive shaft to the shaker fingers. If
hardware requires tightening, use a thread locker to
secure. Inspect all bushings for signs of wear. Also
inspect the rubber grommet that seals the mechanism
to the cabinet for tears or excessive wear.
If it is not time to replace the bags, inspect them for
wear or abrasion around the shaker fingers.
It is recommended that you grease shaker motor every
3,600 hours with high grade gall bearing grease
(i.e. Shell Dolium or Chevron SRI-2).
5.4 SERVICING THE BLOWER
ELECTRIC SHOCK HAZARD
All electrical work should be performed by a qualified
electrician in accordance with local electrical codes.
Disconnect electrical power before installing or
servicing any electrical equipment.
Periodically inspect the fan blades to ensure proper fan
life. Clean the fan blades of any deposited material.
Grease the blower motor every 3,600 hours with high
grade gall bearing grease (i.e. Shell Dolium or
Chevron SRI-2).
Filters can weigh in excess of 125 lbs. Please use
extreme caution when removing from cabinet.
Slide the cassette from the cabinet, as shown
in Figure 12. This will require two people
(or a fork truck), due to the weight of the filter and the
collected dust. When the cassette is removed from the
cabinet, inspect the gasket on the underside of the
tubesheet for damage. If there are cracks or tears it is
recommended that the gasket should be replaced.
Refer to Section 8 for replacement parts.
To replace the filter, remove the inserts from each
pocket as shown in Figure 12. When this is complete,
release the snap band that secures the filter to the
cassette and then lift the filter up through the support
rods and free of the cassette.
Reverse the above directions to install the new filter.
Take care to make sure the filter fabric seats properly in
the filter frame. As the filter cassette is slid into the
cabinet, thread each pocket through the shaker
mechanism teeth. Make sure the wear strips, located
on the bottom-center of each pocket, are in contact with
the shaker fingers.
5.2 DUST REMOVAL
As the SDC system cleans, dust collects in the drum.
The dust should be removed periodically to prevent
re-entrainment, eliminating dust piling up into the
hopper section. Your application will determine the
appropriate intervals between emptying the drums.
To remove the drum barrel, disengage the drum clamp
and lift up the drum lid.
Reverse these directions to replace the drum barrel.
5.3 SERVICING THE SHAKER MECHANISM
On a quarterly basis, remove the shaker mechanism
cover plate and inspect the moving parts of the shaker
mechanism. Refer to Figure 12.
13