U.S. General 47558, Руководство по сборке и эксплуатации

Страница: 8 / 10

Page 8 SKU 47558
Operation
1. Place the Cement Mixer on a solid, even surface.
2. Connect the Power Cord to an GFCI electrical outlet (or properly rated extension
cord) with a third, ground prong.
3. Add material to the Drum.
Typical quantities include: 1 gallon water, 1.5 shovels cement, 7 shovels aggregate
rock using a size 3 shovel. Run mixer until all dry materials are liquified.
Warning: Do not attempt to move the Cement Mixer when it is full and in operation. Per-
sonal injury could occur.
4. Adjust the Drum angle by pulling out on the Adjusting Handle (24), disengaging the
locking pins, and push on Handle until the desired angle is reached. Re-engage the
locking pins.
5. Push the Switch (40) to the (I) or On position.
6. Filling and emptying the Drum is best done with the Drum rotating.
Caution: Never leave the Cement Mixer running while unattended. Do not turn Mixer Off
while full of cement.
7. When finished, flip the Switch to the (O) or Off position, and disconnect the Power
Cord.
8. Turn the Drum angle as far down as possible to drain all fluids from Drum.
Maintenance
1. After use, immediately wash out all debris from the inside and outside of the Cement
Mixer. Make sure the Power Cord is disconnected.
2. Do not apply water in or around the Motor Base Cover.
3. Retighten belt after the first 25 hours of use. The belt should be able to be pressed in
no more that 1/4 inch to indicate correct tension.
4. Add several drops of a light oil to the Pivot Brackets oil hole (at top) during each use,
as the Drum is turning.
5. Periodically recheck all nuts, bolts, and screws for tightness.