U.S. General 47558, Руководство по сборке и эксплуатации

Страница: 6 / 10

Page 6 SKU 47558
8. Attach the Motor Cover (34) to the Motor Mount Plate (32) using Hex. Bolts (35). See
photo E and Assembly Drawing.
9. Attach the Inner Belt Cover (41) to the Pivot Bracket (17) using Hex. Bolt (19), Set
Washer (5), Spring Washer (6), and Hex. Bolt (7). See photo F.
10. Attach the (lower) Inner Belt Cover (41) to the Motor Cover using Hex. Bolt (19), Set
Washer (5), Spring Washer (6), and Hex. Nut (7). Hand tighten. See photo E.
11. Push the Pulley (47) onto the motor shaft. Line up the key slots. See photo E.
Leave a distance of about 3/8 inch between the ball bearing and the Pulley Hub. This
will allow the set screw to properly engage the key. Tap the key into the key slot, then
tighten the set screw.
12. Route the Line Cord end connectors and the motor cord connectors through the hole
in the Inner Belt Cover, up to the Switch (40). See photo E.
Caution: Before making connections to the Switch, verify that the Power Cord is not
connected to an electrical outlet.
13. Plug the Motor line cord connectors into the top tabs of the Switch (white-left; black-
right). Plug the Line Cord connectors into the bottom tabs of the Switch (40).
14. On the Shaft (37), remove the tape and Key (38). Push the Drive Pulley (42) onto the
shaft. Line up the key slots. See photo E.
Leave a distance of about 3/8 inch between the ball bearing and the Pulley Hub. This
will allow the set screw to properly engage the key. Tap the key into the key slot, then
tighten the set screw.
15. Place the Belt (44) onto the Drive pulley (42), then the motor Pulley (47).
16. Since the Motor mount is loose, move the Motor to align both pulleys, eliminating
excess wear on the Belt.
(34)
[E]
[F]
(35)
(41)
(41)
(17)
(19), (5), (6), (7)
(19), (5), (6), (7)
(47)
(37)
(42)
(38)
(40)
REV 12/02