18
The duplicator will detect USB3.1 only. If the device does not support USB3.1 protocol, it
will show “Fail.”
7.4 Target Tolerance
This function sets the capacities tolerance range between the source and target flash. If the
capacity is outside the tolerance range, the copy will fail.
100% Same
No Limit
Allow Tolerance
Set UP Limit: The target capacity can be bigger than the source capacity.
Set UP Limit: The target capacity can be smaller than the source capacity.
7.5 Asynchronous
Users can activate Asynchronous copy by selecting “Enable” or deactivating it by selecting
“Disable” For Asynchronous copy to run, the source’s data must be smaller than the
system’s buffer memory and set to “Enable”. However, if set to “Disable”, regardle
ss of
content size, synchronous copy will be performed.
The conditions of executing “Asynchronous Copy”
DISABLE
Asynchronous Copy
ENABLE
Asynchronous Copy
Data
>
Buffer
Data
<
Buffer
Note
The buffer memory may vary depending on product model.
[Target Tolerance]
Allow Tolerance
[Set UP Limit]
2 %
[Set LOW Limit]
0 %
