PAGE 2 OF 9
0322 IH-9996
SAFETY CONTINUED
INSTALLATION
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning it off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Contact Uline Customer Service at
1-800-295-5510 for help.
WARNING! Turn off main power at circuit
breaker before installing fixture in order to
prevent possible electric shock.
NOTE: This light uses the latest in solid
state lighting technology for long life, low
maintenance and high efficiency.
NOTE: This unit can be mounted on a standard
photocell to the enclosure to make it
completely suitable for street lighting.
NOTE: An internal power-factor-corrected
switch-mode supply allows the product to be
used with any nominal 100V-277V, 60 Hz AC
supply without any variation in light output.
NOTE: Unit is suitable for use in the following
conditions:
• Ambient temperature: -40°F to 104°F
• Wet locations
NOTE: Save these instructions for future
reference.
WALL MOUNT
1. Using Phillips screwdriver, remove two screws to
release the back plate from front cover. (See Figure 1)
2. Align back plate to wall at desired location. Mark
wall using three holes in back plate as a guide.
(See Figure 2)
3. Drill holes in wall at previously marked location.
Insert wall anchors if necessary. (See Figure 2)
4. Align back plate with previously drilled holes. Using
phillips screwdriver, install back plate with three
mounting screws. (See Figure 2)
Figure 2
Figure 1
Back
Plate
Front
Cover