INSTRUCTIONS
A17™ AREA LIGHT INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
A17 Slipfi tter
A17 Universal Pole
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
WARNING: Do not use an electric generator to test LED fi xtures.
WARNING:
Min 75°C SUPPLY CONDUCTORS.
Suitable for wet locations.
MOUNTING THE UNIVERSAL ARM
ON THE FIXTURE
1. Remove the
Arm Cove
r from the
Arm
by loosening
Arm
Cover Screws
as shown in Fig. 1.
2. Feed wires from fi xture into
Arm
.
3. Line up
Arm
and fi xture. Tighten screws inside the
Arm
and
tighten securely to housing.
4. Replace the
Arm Cover
and secure with
Screws
as shown in Fig. 2.
Arm
Screws
Arm Cover
Arm
FIG. 1
FIG. 2
FIG. 3
FIG. 4
Square Pole Mount
1. Place the
Bolster Plate
inside the
Pole
as shown in Fig. 3.
2. Remove the
Round Pole Adaptor Plate
.
3. Fix
Arm
to
Square Pole
with
Bolt
.
4. Open the
Arm Cover
and pull the wires into the junction box.
5. Feed supply wires from the
Pole
to connect to the
Arm
.
Make appropriate wire connections per NEC in an approved
enclosure
(Fig. 7).
6. Use bolts to tighten to the
Pole
.
Round Pole Mount
1.
Place the
Bolster Plate
inside the
Pole
as shown in Fig. 3.
2.
Fix
Arm
to
Round Pole
with
Bolt
.
3.
Open the
Arm Cover
and pull the wires into the junction box.
4.
Feed supply wires from the
Pole
to connect to the
Arm
.
Make appropriate wire connections per NEC in an approved
enclosure
(Fig. 7).
5.
Use bolts to tighten to the
Pole
.
Pole
Bolster Plate
Bolt
Pole
Arm
Round Pole
Adaptor Plate
Arm Cover
Note: See Pole Drilling Pattern Detail
(Fig. 8)
.
