PAGE 3 OF 9
0322 IH-9996
5. Ensure power is off from circuit breaker or fuse. Feed
power supply wires through conduit inlet on back
plate. Connect the wires using wire nuts. (See Figure 3)
6. Assemble front cover back onto back plate. Close
and seal enclosure with two previously removed
screws. (See Figure 4)
JUNCTION BOX MOUNT
1. Open and remove the front cover from the back
plate by using a Phillips screwdriver to remove the
screws. (See Figure 5)
2. Drill four holes on the back plate needed to install
junction box. Using Phillips screwdriver remove center
knockout. Ensure power is off. Feed power supply
wires through the knockout hole. (See Figure 6)
3. Mount the back plate to the junction box and connect
the wires. (See Figure 7)
NOTE: Refer to Figure 3 for proper wire
connections.
4. Assemble front cover back onto back plate. Tighten
enclosure screws to seal fixture. (See Figure 8)
Figure 7
Figure 6
Figure 8
Figure 4
1-800-295-5510
uline.com
Center
Knockout
Figure 3
Supply Line
(Black)
Wire Nut
Supply Neutral
(White)
Line (Black)
Line (White)
LED Driver
Box Grounding (Green)
Factory Wired
LED to Driver
Supply Grounding
(Green)
INSTALLATION CONTINUED
Figure 5
Back
Plate
Front
Cover
