U-Line H-5819, Руководство пользователя

Страница: 9 / 33

PAGE 9 OF 33 0819 IH-5819
ENABLE ACCUMULATION
At startup, the accumulation mode is enabled. Enter this
menu to turn the accumulation mode on or off.
1. Turn on the scale and press the
TARE
key
Tare
during
the self-test.
PO CAL
will be shown on the display.
PO CAL
2. Press the TARE key Tare until
P4 ACC
is shown on the
display.
3. Press the ZERO key
Zero
to enter the menu.
4.
ACC
will be shown on the display. Press the TARE key
Tare
to select on or off. Press the ZERO key Zero to select
the new setting.
5. Press the
TARE
key
Tare
to view additional menus or
press the
MODE
key
Mode
to exit the setup menu.
ENABLE AUTOMATIC ACCUMULATION
At startup, the automatic accumulation mode is
not enabled. Enter this menu to turn the automatic
accumulation mode on or off.
1. Turn on the scale and press the TARE key
Tare
during
the self-test.
PO CAL
will be shown on the display.
PO CAL
2. Press the TARE key
Tare
until
P5 Ato
is shown on the
display.
3. Press the ZERO key
Zero
to enter the menu.
4. Press the
TARE
key
Tare
to change the setting.
• AU on – Automatic Accumulation is on.
• AUoFF – Automatic Accumulation is off.
• P Cont – Continuously send data to PC.
• ASF – Send current data to printer.
5. Press the
ZERO
key
Zero
to select the new setting.
6. Press the TARE key
Tare
to view additional menus or
press the MODE key
Mode
to exit the setup menu.
PRINTER SET-UP
Enter this menu to select a printer.
1. Turn on the scale and press the TARE key
Tare
during
the self-test.
PO CAL
will be shown on the display.
PO CAL
2. Press the TARE key
Tare
until
P6 Prt
is shown on the
display.
3. Press the ZERO key
Zero
to enter the menu.
4. Press the TARE key Tare to change the setting.
• tP – Ticket Printer
• LP-50 – Label Printer
• EPM – EPM205 Printer
NOTE: EPM will only be available for selection if
automatic accumulation is set to auto.
5. Press the ZERO key
Zero
to select the new setting.
6. Press the TARE
key
Tare
to view additional menus or
press the
MODE
key
Mode
to exit the setup menu.
BAUD RATE
Baud rate is the RS232 transmission speed. If using a
printer, both the printer and the scale must be set to the
same baud rate. At startup, the baud rate is set at 9,600.
Enter this menu to change the baud rate setting.
1. Turn on the scale and press the TARE key
Tare
during
the self-test.
PO CAL
will be shown on the display.
PO CAL
2. Press the TARE key Tare until
P8 bud
is shown on the
display.
3. Press the ZERO key
Zero
to enter the menu.
4. Press the TARE key Tare to change the setting.
• EPM
• b 1200
• b 2400
• b 4800
• b 9600
5. Press the ZERO key
Zero
to select the new setting.
6. Press the TARE key
Tare
to view additional menus or
press the MODE key
Mode
to exit the setup menu.
SETUP MENU