U-Line H-5819, Руководство пользователя

Страница: 6 / 33

PAGE 6 OF 33 0819 IH-5819
OPERATION CONTINUED
LACK OF UNIT WEIGHT
The minimum weight must be at least 20 times the
scale accuracy for accurate calculations. Refer to the
minimum weights chart below.
MINIMUM WEIGHTS
Model #
Minimum Sample
Weight
Minimum Piece
Weight
H-5819 0.002 lb. 0.00005 lb.
H-5820 0.01 lb. 0.00025 lb.
H-5821 0.02 lb. 0.0005 lb.
H-5822 0.04 lb. 0.001 lb.
If the unit weight is too light, another scale is needed.
Continuing to use this scale will result in less accurate results.
CHECK WEIGHING
Use this mode to set a number for a weighing check.
When the weight of the objects on the platform is less
than or larger than the preset checking number, the
indicators in the lower right hand corner of the display
will show HI, OK or LOW.
Alarm beeping sounds can be enabled to beep when
weights are in or out of limits. See page 9 to enable.
SET CHECK WEIGHT
1. Press the MODE key
Mode
until
C nEt
is shown on
the display.
2. To set the high limit, press the HI key
MR
HI
.
Current high limit will be shown on the display.
3. Key in the high limit by using the numeric keys and
press the
ZERO
key
Zero
.
4. To set the low limit, press the LO key
MC
LO
. Current
low limit will be shown on the display.
5. Key in the low limit by using the numeric keys and
press the ZERO key
Zero
.
CHECK WEIGHT OPERATION
1. Press the MODE key Mode until
C nEt
is shown on
the display.
2. Place item to be weighed on the scale platform.
Weight will be shown on the display. Scale indicators
will show if weight is out of specified HI/LOW range.
CLEAR CHECK WEIGHT
1. Press the MODE key
Mode
until
C nEt
is shown on
the display.
2. Press the
HI
key
MR
HI
. Current high limit will be shown
on the display.
3. Enter 0 using the numeric keypad.
4. Press the ZERO key
Zero
.
5. Press the LO key
MC
LO
. Current low limit will be shown
on the display.
6. Enter 0 using the numeric keypad.
7. Press the ZERO key
Zero
.
CHECK COUNTING
Use this mode to set a number for a counting check. When
the number of objects on the platform is less than or larger
than the preset checking number, the indicators in the lower
right hand corner of the display will show HI, OK or LOW.
SET CHECK COUNT
1. Press the MODE key
Mode
until
C PCS
is shown on
the display.
2. To set the high limit, press the
HI
key
MR
HI
. Current
high limit will be shown on the display.
3. Key in the high limit by using the numeric keys and
press the ZERO key
Zero
.
4. To set the low limit, press the LO key
MC
LO
. Current low
limit will be shown on the display.
5. Key in the low limit by using the numeric keys and
press the ZERO key
Zero
.
CHECK COUNT OPERATION
1. Press the MODE key
Mode
until
C PCS
is shown on
the display.
2. Follow counting steps on pages 4-5. Scale indicators will
show if the total quantity is out of specified HI/LOW range.
3. Press the U/N/G key
U/N/G
to display the unit weight,
gross weight and total quantity.