8
Form
122175
5. MOUNTING THE INVERTER
Note:
Before mounting the inverter system, read the safety
instruction section on page 3.
5.1 Tools for Installation:
The following tools are needed for inverter
installation: Crimper, Cable ties, Cutter, Drill, # 2 Phillips Screw driver, Tape measure,
Wire cutters, Wire Strippers.
5.2 Mounting Recommendations:
FIGURE 3: Inverter mounting footprints (dimensions are in inches)
Note:
The inverter mounting location should provide adequate
ventilation and clearance to maintain room temperature during
operation. At least 1/2 inch of clearance is required on all sides.
1
Locate a suitable, secure vertical or horizontal mounting surface as close to the
batteries as possible without being in the same airtight compartment.
2
If mounting the inverter on a vertical surface, it is recommended that the front
control panel be pointing down whenever possible.
3
Locate the mounting holes on the chassis flanges and fasten them using ¼ inch
diameter screws to secure the inverter.
0.40
0.40
12.00