XPLR-HPG-1 - User guide
UBX-23000692 - R01
Getting started
Page 33 of 37
C1-Public
4.4
Mounting the Click boards
XPLR-HPG-1 comes pre-assembled in a Takachi EXPF15-6-11 enclosure with all Click boards already
mounted on the C213 baseboard. However, if you need to disassemble and reassemble the kit, follow
these instructions to mount the Click boards correctly to the C213 baseboard:
1.
Prepare GNSS RTK 2 and LBAND RTK (optional for correction data through L-BAND) Click boards
a)
Stack GNSS RTK 2 Click board on the top of LBAND RTK Click board
b)
Insert the stacked GNSS RTK 2 and LBAND RTK boards in mikroBUS slot 3.
2.
Prepare 4G LTE 2 (LARA-R6) Click board (optional for correction data through LTE)
a)
Insert a nano SIM (with active data plan) into the card holder on the 4G LTE 2 Click board
b)
Insert LARA-R6 click board on mikroBUS slot 1.
The C213 baseboard with the mounted Click boards is now ready for assembly into the enclosure. The
board configuration is suitable for all
shows the GNSS RTK 2 board stacked on the top of LBAND RTK Click board in mikroBUS 3
with the 4G LTE 2 Click Board mounted in mikroBUS 1.
Figure 26: C213 baseboard with the mounted Click boards ready for assembly
Two female 1x8-pin header connectors located in parallel with one another on the top side of the
LBAND RTK provide the physical interface for stacking the GNSS RTK 2 board.
