u-blox XPLR-HPG-1, Руководство пользователя

Страница: 31 / 37

XPLR-HPG-1 - User guide
UBX-23000692 - R01 Getting started Page 31 of 37
C1-Public
4 Getting started
The XPLR-HPG-1 explorer kit comes pre-assembled in a Takachi EXPF15-6-11 enclosure – with all
Click boards already mounted on the C213 baseboard. Simply connect the antennas and the kit is
ready to use out-of-the-box.
☞
XPLR-HPG-1 does not include a battery or SIM card. As the holders for these components are
inaccessible when the kit is fully assembled, you must disassemble the kit to fit them
– if needed.
See also Inserting the SIM and battery .
Figure 25: Kit enclosure showing access to antennas, buttons, switches, and connectors
4.1 Connecting the antennas
To start using the kit, simply connect the antennas:
1. Connect the L-band antenna to the SMA connector of the LBAND RTK Click board
2. Connect the GNSS antenna to the SMA connector of the GNSS RTK 2 Click board
3. Connect the two LTE antennas to the SMA connectors of the 4G LTE 2 Click board
4.2 Inserting the MicroSD card
A MicroSD card (not included in the kit) is only required if you intend to record logfiles from the GNSS
RTK 2 Click board. An access hole in the protective plexiglass of the enclosure allows you to plug the
card directly into the holder, as shown in
Figure 25 .
4.3 Inserting the SIM and battery
The kit is ready to use out-of-the-box but must be reassembled for:
• Cellular operation – requiring the installation of a SIM card (use case 2)
• Standalone operation – requiring the installation of a battery
If either of these components are required in your application, you must disassemble the kit to fit
them.