NORA-W10 series - System integration manual
UBX-22005601 - R04
Regulatory compliance
Page 40 of 56
C1-Public
To ensure that the max output power of NORA-W10 remains below the SAR Test Exclusion Threshold
defined in KDB 447498 D01v06, an OEM integrator implementing NORA-W10 WLAN capability into
an end-product must ensure a separation distance of at least 63 mm between the user (or bystander)
and the antenna (or radiating element). The separation distance may be reduced to 34 mm in
applications where the WLAN capability is turned off and only the Bluetooth LE capability of
NORA-W10 is utilized.
☞
KDB 996369 D03 section 2.4 (limited module procedures) is not applicable to NORA-W10 series
modules.
☞
KDB 996369 D03 section 2.5 (trace antenna designs) is not applicable to NORA-W10 series
modules.
6.4.5
End-product user manual instructions
6.4.5.1
ISED compliance
The NORA-W10 module is certified for use in Canada under Innovation, Science and Economic
Development Canada (ISED) Radio Standards Specification (RSS) RSS-247 Issue 2 and RSSGen. The
host product shall be properly labelled to identify the modules within the host product.
☞
The final host device, into which this RF Module is integrated" has to be labeled with an auxiliary
label stating the IC of the RF Module, such as" Contains transmitter module IC: 8595A-
NORAW1W2
☞
Le périphériquehôte final, danslequelce module RF estintégré "doitêtreétiqueté avec
uneétiquetteauxiliaireindiquant le CI du module RF, tel que" Contient le module émetteur IC:
8595A-NORAW1W2
☞
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licen
se-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
☞
L’émetteur/récepteur exempt de licencecontenudans le présentappareilestconforme aux CNR
d’Innovation, Sciences et
Développementéconomique Canada applicables aux appareils radio
exempts de licence. L’exploitationestautorisée aux deux conditions suivantes:
(1) L' appareil ne doit pas produire de brouillage.
(2) L' appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d' encompromettre le fonctionnement.
6.4.6
End-product labeling requirements
6.4.6.1
ISED Compliance
The host product shall be properly labelled to identify the modules within the host product.
The Innovation, Science and Economic Development Canada certification label of a module shall be
clearly visible at all times when installed in the host product; otherwise, the host product must be
labelled to display the Innovation, Science and Economic Development Canada certification number
for the module, preceded by the word “contains” or similar wording expressing the same meaning, as