JODY-W2 - System integration manual
UBX-18068879 - R14
Regulatory compliance
Page 63 of 84
C1 - Public
The evaluation of the end product shall be performed with the JODY-W2 module installed and
operating in a way that reflects the intended end product use case. The upper frequency
measurement range of the end product evaluation is the 10th harmonic of 5.8 GHz as described in
KDB 996369 D04.
The following requirements apply to all products that integrate a radio module:
•
Subpart B - UNINTENTIONAL RADIATORS
To verify that the composite device of host and module comply with the requirements of FCC part
15B, the integrator shall perform sufficient measurements using ANSI 63.4-2014.
•
Subpart C - INTENTIONAL RADIATORS
To validate that the fundamental and out of band emissions of the transmitter part of the
composite device complies with the requirements of FCC part 15C, it is required that the
integrator carries out sufficient verification measurements using ANSI 63.10-2013.
When the above requirements are fulfilled the end product manufacturer can use the authorization
procedures, shown in Table 1 of 47 CFR Part 15.101, before marketing the end product. This means
that the customer has to market the end product under a
Suppliers Declaration of Conformity (SDoC).
Alternatively, the product must be certified by accredited test lab.
The description of the FCC regulatory requirements in this document comprise a subset of applicable
publications maintained by the FCC Office of Engineering and Technology (OET) Knowledge Database
(KDB). We recommend that integrators read the following list of KDB reference documents:
•
KDB 178919 D01 Permissive Change Policy
•
KDB 447498 D01 General RF Exposure Guidance
•
KDB 594280 D01 Configuration Control
•
KDB 594280 D02 U-NII Device Security
•
KDB 784748 D01 Labelling Part 15 18 Guidelines
•
KDB 996369 D01 Module certification Guide
•
KDB 996369 D02 Module Q&A
•
KDB 996369 D04 Module Integration Guide
United States compliance statement (FCC)
shows the FCC IDs allocated to JODY-W2 modules.
Model
16
FCC ID
JODY-W263-00A, JODY-W263-01A, JODY-W263-00B,
JODY-W263-10B
XPYJODYW263
Table 31: FCC IDs for different variants of JODY-W2 modules
JODY-W2 modules have modular approval and comply with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
3.
This device may not cause harmful interference, and
4.
This device must accept any interference received, including interference that may cause
undesired operation.
⚠
Any changes or modifications NOT explicitly APPROVED by u-blox could cause the JODY-W2
module to cease to comply with FCC rules part 15 thus void the user's authority to operate the
equipment.
16
The model name is identical to the ordering code. For details, see the JODY-W2 data sheet
