Press
S
button, the most recent test result will appear. Each
time you press the
S
button, the TysonBio SUPERB Meter will
recall the last 300 test results accordingly. When the memory is
full, the oldest result is removed and replaced with the newest
result.
Press and release the
S
button to the end of the memory, “000”
will show. Then press the
S
button again or
M
button to turn
the meter off.
6.
7.
To Record Your Results
We have provided a log book for your recording convenience. To learn more about how to record your
results, please refer to the log book for further instructions.
Exiting the Memory Mode
1. Press the
M
button to turn off the meter.
2. Meter will shut down automatically after 4 minutes with no further action.
Note: The consecutive 7/14/30-day average is calculated from the blood glucose results obtained
during the last consecutive 7/14/30-day.
AM
Mem
mg/dL
Mem
You can use your meter with TysonBio Link Health Management Software to transfer test results to your
personal computer.
Obtain the required software and cable
For order information please call Tyson Bioresearch, Inc., Customer Service at +886-37-585998 or
website of
www.tysonbio.com
Install the software on a computer
Follow the instructions provided with software to install the software.
Transfer data
Follow the instructions provided in the software to download the results from the meter. After
finishing the data transfer, press
M button
to turn off the meter.
Note: While in the communication mode, you will be unable to perform a blood glucose test. If the
meter is not in the PC link mode, it will not respond to computer commands.
1.
2.
3.
4.
Transfer Test Results to a Computer
Get ready to transfer test results
Setting the meter to the PC link mode, see page.21. “PC” will appear on the
display. Connect the interface cable to a serial port on your computer. Then
connect the other end of interface cable to the data port located on
the side of the meter
with the meter turned off.
35
36
