- 52 -
18. Performing cycle sewing
The sewing machine can perform the sequential sewing of plural cycle sewing pattern data.
The maximum of 30 patterns can be input, so you can use it when sewing the buttonholes of two or more
different sewing products.
Moreover, it can register the maximum of 20 data.
Please copy it before use if required.
→
Refer to
“V-14. Copying sewing pattern” P.39.
(1) Selection of cycle data
1) Set the mode to the input mode
Under the input mode where Set Ready LED
goes
out, the continuous-sewing data selection is enabled. In
sewing mode, press Ready key
❷
to change
over the mode to input mode.
The continuous sewing data can be selected only in data
mode.
2) Selection of cycle sewing data
Press Item Selection key
❻
and then the selected
patterns will be displayed sequentially, and after pattern
No. is selected, the selected cycle data No. and
continuous sewing data No. will be displayed. Now,
select the intended sewing data No.
3) Perform sewing
When the continuous sewing data is selected, press the
Ready key
❷
, then the Set Ready LED
will light up, indicating that the sewing is enabled.
Continuous stitching data No. 1 only has been
registered at the time of your purchase. Sewing status
cannot be obtained since the sewing pattern has not
been input. Therefore, please refer to (2)
Editing
method of continuous sewing data
next page for input.
Содержание GT1790A
