TYCROP Manufacturing Ltd.
ProPass 180 Top Dresser Operator’s Manual
How to Wash the ProPass
Salts, road tar, tree sap, fertilizers, or chemicals may
damage the painted finish of the ProPass. Wash off these
deposits as soon as possible with detergent and water.
Additional cleaners or solvents may be needed, but ensure
that they are safe for painted surfaces.
W
ARNING
:
Do not use flammable fluids
or cleaners with toxic vapors. Follow the
manufacturer’s recommendations.
I
MPORTANT
:
Do not use a high-pressure washer. This
can remove paint, safety decals, and grease, and can
also damage components.
1.
Remove the attachment before cleaning and wash it
separately.
2.
Wash the body of the ProPass with warm water and a
mild detergent.
3.
Completely rinse off the detergent residue with clean
water before it dries.
4.
Remove the belt cleaning scraper assembly from the
rear of the ProPass.
Figure 31: Belt cleaning scraper assembly
5.
Raise the front of the ProPass as high as necessary.
6.
If you have a truck-mounted ProPass, use the lift
cylinder on the tow vehicle. (See the tow vehicle’s
owner’s manual.)
7.
If you have a tow-behind chassis, use the jack stand
on the chassis.
8.
Fully open the rear gate and spray water inside the
hopper assembly and the rear gate area. Inspect the
side seals and replace if necessary.
9.
At the rear of the ProPass, spray small amounts of
water (2 to 3 seconds at a time) between the belt and
the bottom guard towards the front of the ProPass. Let
the water drain down the bottom guard and onto the
ground. Repeat until clean.
10.
Inspect the hopper, bottom guard, conveyor belt, bed,
and rollers to ensure that all trapped material is gone.
11.
Lower the ProPass back into the normal operating
position.
12.
Re-install the belt cleaning scraper assembly. Push the
scraper mount bar onto the belt. Ensure that the
scraper is as vertical as possible, but still in contact
with the belt.
Long-term Storage of the ProPass
Before storing the ProPass for the season:
1.
Thoroughly clean the ProPass. Remove parts if
necessary.
2.
Pay special attention to the suspension and tires, and
the area between the belt and the cartridge.
3.
Check all fasteners and tighten if necessary.
4.
Grease all fittings and pivot points. Wipe off any
excess lubricant.
5.
Apply a “never seize” product to the idler roller and
the drive roller shafts.
6.
Lightly sand any painted areas that are scratched,
chipped, or rusted, and apply touch-up paint.
7.
Store the ProPass indoors if possible.
Page 36
Maintenance Instructions
