TYCROP Manufacturing Ltd.
ProPass 180 Top Dresser Operator’s Manual
Figure 16: Electrical connection on tow vehicle
15.
Connect the ProPass hydraulic lines to the tow
vehicle’s hydraulic connections (at the rear; see Figure
17). The line with the one-way flow check valve
connects to the return connection on the tow vehicle.
Figure 17: Hydraulic connections
16.
Connect the on/off pendant and place it in the cab of
the tow vehicle. Ensure that both switches are off.
Removing the ProPass from a Tow
Vehicle onto the Storage Stand
1.
Park the tow vehicle in the storage spot for the
ProPass.
2.
Disconnect the electrical connection from the tow
vehicle (Figure 16).
3.
Disconnect the ProPass hydraulic lines from the tow
vehicle (Figure 17).
4.
Remove and store the on/off pendant.
5.
With the tow vehicle in neutral gear, set the parking
brake and start the engine.
6.
Using the vehicle lift cylinder, raise the front of the
ProPass high enough for the front storage stand legs.
7.
Turn off the engine.
8.
Insert the front and rear storage stand legs and secure
them with locking pins.
9.
With the tow vehicle in neutral gear, set the parking
brake and start the engine.
10.
Using the vehicle lift cylinder, lower the front of the
ProPass until the front storage stand legs begin to
touch the ground.
11.
Turn off the engine.
12.
Raise the two rear storage jack stands until the
pressure is off the rear mounting pins.
13.
Remove the rear mounting pins. (If necessary, wiggle
the ProPass.)
14.
With one hand, hold the lift cylinder. With the other
hand, remove the lift cylinder’s locking pin. (If
necessary, wiggle the lift cylinder control.)
15.
Rest the lift cylinder in the appropriate location on the
tow vehicle’s frame.
16.
Walk around the ProPass. Ensure that it is clear of the
tow vehicle’s frame and secured within each of the
four storage stand legs.
17.
With the tow vehicle in neutral gear, set the parking
brake and start the engine.
18.
Release the parking brake and slowly drive the tow
vehicle forward, away from the ProPass truck-mount
on the storage stand (Figure 14).
W
ARNING
:
Do not climb under or
perform work on the ProPass while it is
on the storage stand.
Operating Instructions
Page 23
