Tyco Security Products DSC TL8803GI-IL2, Руководство пользователя

Страница: 8 / 53

- 8 -
Installation
I
NSTALLATION
Follow these guidelines during installation.
l
Before affixing the communicator to a wall, verify the HSPA signal level at the installation location. On a
keypad, press and hold the 5 key for 2 seconds to view the HSPA signal level. An installation location
with a sustained signal level of two or more bars is recommended.
l
Do not exceed the panel total output power when using panel power for the TL8803GI-IL2 module,
hardwired sensors, and /or sirens. Refer to the specific panel installation instructions for details. Only one
module can be used per panel.
l
To minimize potential interference with cellular signaling, avoid mounting the communicator in areas with
excessive metal or electrical wiring, such as furnaces or utility rooms.
Do not mount the TL8803GI-IL2 communicator inside of the metal alarm panel enclosure.
Tools and supplies required
You will need the following tools and supplies:
l
Small flat-head and Phillips screwdrivers
l
Screws (included)
l
Antenna (included)
l
16 pin ribbon cable (included)
Mounting Instructions
Before fixing the equipment to the wall, verify the HSPA signal level available at the installation location is
strong.
Mount the TL8803GI-IL2 in a dry, secure, non-hazardous location.
To wall mount:
1. Insert a flathead screwdriver into the slots and pry up to remove the front cover.
Figure 1 - Removing the front cover
2. For surface-run wires, remove the two breakaway tabs at the side of the backplate.
3. Route the RS422 and Ethernet cables through the retaining clips as shown in figure 2. Run the wires in the
direction indicated by the arrows.
Note : For information on control panel power specifications, refer to the control panel installation
manual.
Caution : Route all the wiring according to local codes and regulations.