409–10052
SDE Electric Bench Terminator 1490076–2
Rev O
10 of 13
5. CRIMP HEIGHT ADJUSTMENT
Crimp height adjustment is only required only if the crimp height listed in the Tyco Electronics die specification
is not achieved.
Adjust the crimp height with a flat–bladed screwdriver.
There are four different crimp heights. Refer to Figure 10.
Although Tyco Electronics normally recommends Position No. 2 (adjustment of the manufacturer), Positions No. 3 and
No. 4 increase the travel of the tool head, which decreases the crimp height. Position No. 1 decreases the the travel of
the head, which increases the crimp height.
Figure 10
Crimp Height Adjustment
(One Step Equals 0.1mm [.004 In.])
NOTE
