8 Port SNMP Managed Switch – User Manual
Page
23
Product Number 0-15910xx-x
© Tyco Electronics 2004
PL0357 Issue A
Port Enable
This allows the copper RJ-45 or fibre uplink port to be set to accept and process traffic. The
default setting is Enabled.
Port Auto-Negotiation
This allows the copper RJ-45 port to be set to negotiate the optimum mode with the connected
equipment. The default setting is Enabled.
Port Speed/Duplex
This allows the copper RJ-45 or fibre uplink port to be set to negotiate the optimum mode with
the connected equipment. Note that this setting is superceded by the Port Auto-negotiation
mode. For example, if the port is set to Auto-Negotiate, then the Port Speed/Duplex mode is
ignored. The default setting is 100Mbit/s and Full Duplex.
Port Flow Control
This allows the copper RJ-45 or fibre uplink port to negotiate with connected equipment to
implement a flow control process using embedded Pause frames. The default setting is On.
Port Group
This allows the copper RJ-45 port to be a member of any 1 of 4 separate trunk groups. Select
the option and use the <Space> key to toggle between the available trunk groups (1-4). In this
trunk mode, the selected ports are made members of the same trunk group to create an
aggregated higher speed link. The default setting is None.
Notes:-
1. The fibre uplink port cannot be a member of a trunk group.
2. The members of the trunk group must all operate at the same speed.
