http://www.tyan.com
48
Creating a Security Array with an Existing Data Drive
You would use this method is you wish to use a drive that already contains data and/or is the bootable
system drive in your system. You will need another drive of identical or larger storage capacity.
Choose
Security
under the
Optimize Array for
section.
Press
<Ctrl-Y>
keys to Save your selection. The window below will appear.
Press “Y” for the
Create and Duplicate
option. The window below will appear asking you to
select the Source drive to use. FastBuild will copy all data from the Source drive to the Target
drive.
Use the arrow keys to choose which drive contains the existing data to be copied.
Press
<Ctrl-Y>
keys to Save selection and start duplication. The following progress screen will
appear.
NOTE:
If you wish to include your current bootable drive using the Windows NT 4.x or Win-
dows 2000 operating system as part of the bootable Mirrored (RAID 1) array on your
FastTrak100 do
NOT
connect the hard drive to the FastTrak100 connector yet. You
MUST
install the Windows NT 4.x or 2000 driver software first (from the driver disk)
while it is still attached to your existing hard drive controller. For all other operating
systems, continue using the following steps listed below.
NOTE:
If you are planning to use your old hard drive, backup all necessary data first. Always
backup the data on an existing hard drive if you are planning to use it in a new sys-
tem configuration.
1
Step
2
Step
3
Step
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
Source Disk
Channel:ID Drive Model Capacity (MB)
Target Disk
Channel:ID Drive Model Capacity (MB)
[Please Select a Source Disk]
Channel:ID Drive Model Capacity (MB)
1 : Master QUANTUMCR8.4A 8063
2 : Master QUANTUMCR8.4A 8063
[ ] Up [ ] Down [ESC] Exit [Ctrl-Y] Save
4
Step
5
Step
Start to duplicate the image . . .
Do you want to continue? (Yes/No)
Y - Continue N - Abort
NOTE:
FastTrak100 permits only two drives to be used for a single Mirrored array in Auto
Setup. If a third drive is attached, it becomes a “hot” spare drive. If four drives are
attached, the Mirroring option will not be available at all.
