http://www.tyan.com
6.8 System Board
!
CAUTION
:
Most repairs to the Tyan MicroServer should only be performed by a professional
service technician. Basic repairs and troubleshooting can be done if authorized in
the product documentation or if directed by telephone or online support from
Tyan. If damage has occurred due to repairs or service that is not approved by
Tyan, the product warranty becomes invalid. Review all safety guidelines that are
provided with the Tyan MicroServer.
6.8.1 Removing a Bridge Board
Prerequisite:
Power down the system.
Disconnect all cables and peripherals from the compute blade(s).
Remove the compute blade. Refer to
Removing a Compute Blade
.
Remove the hard drive. Refer to
Removing a Hard Drive
.
1. Remove four (4) screws from the bridge board. (Figure 4-13)
2. Slide and disconnect the bridge board from the system board.
3. Lift and remove the bridge board from the compute blade.
Bridge
Board
Connector
System
Board
Figure 4-12. Removing the Bridge Board
6.8.2 Installing a Bridge Board
1. Lower the bridge board onto the compute blade. (Figure 4-12)
2. Slide and connect the bridge board connector to the system board.
3. Install and secure the bridge board with the four (4) screws.
4. Install the compute blade into the chassis. See
Installing a Compute Blade
.
