S1836 Thunder 100
49
8. Click OK when finished.
9. Click OK to restart Windows 95.
Other operating systems
See the Adapter Installation and Special Configurations README file.
“Push” Installation for Windows 95
If you are a LAN Administrator setting up server-based push installa-
tion of Windows 95 as defined in Microsoft Windows 95 Resource Kit,
additional steps are required for this adapter. Refer to the Push Installa-
tion for Windows 95 README file under the Microsoft section of
Installing EtherExpress PRO/100B adapter drivers.
Troubleshooting
If the adapter can’t connect to the network:
·
Make sure the cable is installed properly. The network cable must
be securely attached at both RJ-45 connections (adapter and hub).
If the cable is attached but the problem persists, try a different
cable. The maximum allowable distance from adapter to hub is 100
meters. If you’re directly connecting two computers (no hub), use
a crossover cable. Most hubs require a straight-through cable,
while most switches require a crossover cable (see your hub or
switch documentation to verify). See the Cabling Information
README file for more information on cross-over cables.
·
Check the LED lights on the adapter. The on-board cable connec-
tor has two diagnostic LEDs. These lights help indicate if there’s a
problem with the connector, cable, or hub. The table below de-
scribes the LEDs, and the drawing on the next page shows their
location.
ONBO
ARD
