S1836 Thunder 100
37
Cache Memory
Penitum II processors have the L2 (Level 2) cache built into their
architecture, so there is no need for an L2 cache on the motherboard.
The Pentium II processor has a phsyical L2 cache size of 512KB and a
cacheable memory area of 512MB.
Intel Ethernet Setup and Use
The S1836DLUAN-GX has the Intel 82558 10/100 Ethernet chip
onboard, which makes setting up your Ethernet connection quite simple.
The following installation and configuration instructions are courtesy of
Intel, and the copyright on the information belongs to Intel Corporation.
For more information, data sheets, white papers, or demos, visit their
networking web site at http://www.intel.com/network.
You can use your modem or Internet connection to download drivers,
troubleshooting tips, and more. When downloading new drivers, make
sure the archive is for the PRO/100B adapter (not PRO/100). This
information can be found on Intel’s website, as well as their FTP site
and BBS service.
Connect the Network Cable.
Connect a single network cable to the PRO/100B TX PCI adapter. The
cable will only fit one way. For 100BASE-TX, your network cable must
be category 5, twisted-pair wiring. If you plan on running the adapter at
100 Mbps, it must be connected to a 100BASE-TX hub (not a
100BASE-T4 hub). For 10BASE-T, use category 3, 4, or 5 twisted-pair
wiring.
100BASE-TX Wiring: Twisted Pair Ethernet (TPE). Use category 5
cable and RJ-45 connector for this adapter. Do not use category 3
wiring at 100 Mbps. At 100 Mbps, connect to a TX hub, not a T4 hub.
For full duplex, see instructions on page 13. Note: For more information
on 100BASE-TX wiring requirements and limitations, see “Fast
procedure
1.
2.
3.
ONBO
ARD
