Twose TF5500, Руководство по эксплуатации

Страница: 41 / 52

32
REMOVING THE MACHINE FROM THE TRACTOR
Select a good clear, level and firm site on which to detach and store the machine.
IMPORTANT
Use the hydraulics to lower the head onto the ground
horizontally (as if you were cutting
grass).

Disengage the PTO drive.

STOP THE TRACTOR ENGINE.

Take the 'T' stand leg from its 'stored' position and put it into its 'down' position,
securing it with the lynch pins provided.
NOTE: -
Long-foot of 'T' stand MUST be furthest from tractor to ensure maximum
stability.

Slacken both setscrews on stabiliser arms, remove the lynch pins from the stabiliser
locating pins, and remove pins. It may be necessary to slightly raise three-point linkage
to 'free' pins, for removal.

Lower hedgetrimmer so stands are on the floor, by means of lowering tractor three-
point linkage.
(Top link may have to be adjusted to ensure trimmer is upright and safe).

When you are sure that trimmer is properly settled and safe on its stands, operate boom
'1' lever to release hydraulic pressure from ram.

Disconnect top link assembly from stabiliser end.

Uncouple stabiliser 'A' frame from tractor top link position - by removing lynch pin and
tractor top link pin.

Remove control handles from tractor and ‘stow’ off the ground in a location where it is
protected from damage.

Disconnect Power Take off shaft and anti-spin chains
(tractor end).
For Pin Type Lower Link Arms

Remove lynch pins from lower lift pins and remove pins from linkage.
For Quick Hitch Crook on Arms

Release crook lock levers on lower link arms and lower/drop arms away.
Tractor linkage arms are now free of the machine.

Draw tractor slowly away - Many operators stop about 300mm (12") away to double-
check that tractor and machine have completely separated and that no connections or
couplings remain connected.
Safety screens can now be removed if so desired.