Two Technologies JETT XL, Руководство пользователя

Страница: 31 / 58

O
PERATION
3-11
By default, the Screen Capture program is set to take a picture by pressing HotKey1 after a five-
second delay.
2.
To change the wait time before the Screen Capture program takes a picture, tapping the up or
down scroll bars under
Capture Delay (sec) . The default value is five seconds.
3.
To change the Keyboard Hot Key assignment, you must access the Hot Key applet in the Control
Panel. The default value is five HotKey1
4.
To have the Screen Capture program take a picture when you tap its icon in the System Tray, check
Auto run in the task bar .
Note: To deselect this option after making it active, tap and hold the icon until the Screen Capture
program appears.
5.
To view the picture immediately following the screen capture, check View following capture .
6.
To change the default folder (My Document) where picture are stored, tap the button under Store
screen capture in folder .
7.
Select a new location and tap OK .
8.
By default the Screen Capture program, automatically assigns a number to each screen capture.
The numbering scheme starts at JET00000 and increment by one after each capture. To set this
number back to JET00000, check
Reset the counter .
Note: Screen captures stored in folders other than the SystemCF folder will be lost if you remove power
from the unit.
W
ARM
B
OOT
Occasionally, a program may encounter an error from which it cannot recover. In these cases, you
can perform a warm boot, which will reinitialize the unit without affecting the contents store in
virtual memory.
To perform a warm boot:
1.
Select Programs > Tools> Warm Boot . The “Are you sure” prompt appears.
2.
Tap Yes to warm boot the unit.