Rev: 2015.06.28.v01c
page 7
the build
CONSTRUCTION METHODS:
Building surface should be at least 2ft x 4ft and at. Weights or some small heavy objects will be handy for holding things in place
during the time glue is setting.
Welders glue is used for FOAM TO FOAM joints. Thin and Medium CA are used on the PLASTIC TO FOAM and CARBON TO FOAM
joints. When using the Welders glue for a butt joint, apply a thin lm to each surface, allow to sit for approx ve minutes and
then assemble. Note that this method will create a nearly instant bond, so locate carefully when bringing the two pieces together. If
alignment is necessary or a slip joint, do not allow the glue to tack up, simple apply and join immediately, you will have several
minutes to locate the two parts before the glue sets up. In most cases the parts being glued can be handled with care in 30 minutes,
full cure is approx 24 hours.
The above picture items will be needed to nish the model.
A power combo (Twisted Hobbys’ Combo pictured above), a
3s/1300mAh battery and a fresh tube of Welders. Note -
the Battery and Welders are NOT part of the power combo,
everything else shown is.
Start the build by locating the two wing halves, the elevator
and the rudder. Fold back as shown and weigh them down
for about an hour. This will loosen up the hinge line and
allow the surfaces to move much more freely. The wing
hinge will be stiff... work it slowly so it doesn’t tear
