C2-2450A O
PERATION
M
ANUAL
103
15.11
The RGB input is selected but the image is rolling or pink.
Check the Adjust sources menu and confirm that the input type and sync method is
set correctly. (Having YUV input selected, instead of RGBHV often causes this
problem).
15.12
The video signal from my DVD player does not appear to work.
Some DVD players have a switch at the back that selects between ‘Component’
and ‘S-Video’ output, because most will not let you output both at the same time.
Make sure it is in the right position for the output you want.
15.13
Image is flashing, snow is present, or source image does not appear.
You may be experiencing a HDCP compatibility problem.
If one of the sources you are using is HDCP encrypted, and your unit is not set to
output HDCP, then your unit will not allow the source image to pass through the unit
(it may flash on and off).
The solution (if your unit supports HDCP) is to ensure it is enabled in both ‘Adjust
outputs’ and in the ‘Adjust sources’ menu for that source signal.
If you unit does not support HDCP, or your output device does not support HDCP
(e.g. an analog monitor), then there is no way to display a HDCP encrypted source
signal.
