ACM 400 S motor control unit
17 / 24
9) Operation
This chapter is intended for the fitter and further processing industry
– however it is
not for issuing to the owner/operator of the gate system.
The end product manufacturer is responsible for preparing instructions for the gate
system suitable for issuing to the owner/operator.
You can find information on this e.g. in the following standards and regulations:
ZH 1/494: Guidelines for power operated doors and gates
DIN EN 60335-2-95: Requirements for vertically moved garage gates in
residential facilities
EN 12445 + EN 12453: Safe use of power-operated gates
DIN EN 62079: Instructions
There are also legal requirements for regular checking of the safety devices.
You must point out to the owner/operator that if drive units are remotely controlled,
they must always have direct eye contact with the moving gate in order to avoid
accidents.
a) Self-test
The control unit constantly performs various self-tests. If an error occurs the control
unit is locked and an error message is displayed (see table on page 15).
Faulty self-tests are automatically repeated after around 1 min. If an error then
occurs again, the next self-test is carried out by an external command (e.g. Pulse,
but not via radio).
Self-tests are carried out...
immediately after the control unit is switched on,
around 1s after reaching the limit position "Closed",
after a motor has been running for 20 min,
around every 4 h in idle mode.
If an error message occurs continuously please contact our service department.
b) Normal operation
[X2.1], [X5.1]
After a successful self-test, the control unit is ready to use.
This is indicated at the
LEDs
in the optional membrane keyboard [X5.1] if ...
the green LED "running" is lit,
the red LED "S" however, is not lit.
Or by a
transverse bar
in the left-hand display segment [X2.1].
Bar in left-hang display segment
Gate status
At top
limit position "Open"
In the middle
gate at standstill along the path
At bottom
limit position "Closed"
moves upwards
Opening
Moves downwards
Closing
