Tuthill KINNEY 850D, Руководство оператора

Страница: 8 / 38

8
5. INSTALLATION
5.1 GENERAL
KT pumps should always be operated with the pump in a vertical and level position. KT pumps should never
be installed in a horizontal or angled position. Pump assembly should be placed on a foundation and should
be supported evenly. Pump assembly should be leveled to within 0.02” (0.5 mm) in any 3.28 ft (1 meter).
SAFETY
DANGER
Internal and external rotating parts of the pump and driving equipment can
produce serious physical injuries. The pump should never be run with the
inlet or discharge piping removed. If it becomes necessary to inspect the
rotating parts of the pump or to change the belt, be absolutely sure that all
power to the motor controls has been shut off, the motor controls are locked
out, and properly tagged before proceeding.
WARNING
Vacuum Pump housing and associated piping or accessories may become
hot enough to cause major skin burns on contact as a result of process
conditions.
WARNING
Use lock out/tag out procedures to disable the electrical energy source
before any service or work is done on the vacuum pumps.
CAUTION
Avoid extended exposure in close proximity to machinery with high intensity
noise levels. Wear adequate ear protection.
CAUTION
Other potential hazards to safety may also be associated with operation
of this equipment. All personnel working in or passing through the area
should be warned by signs and trained to exercise adequate general safety
precautions.
NOTE
Use proper care and good procedures in handling, lifting, installing,
operating, and maintaining the equipment.