09
English
4.1 TPMS Sensor Installation:
(Fig 1)
(Fig 2)
(Fig 3)
(Fig 4)
(Fig 5)
(Fig 6)
gromment(0.625” or 0.453’’)
screw
nut
cap
washer
metal valve stem
0.625”
0.453’’
(Fig 1) & (Fig 2) Deflate and remove the tire from the wheel using a tire mounting machine.
(Fig 3) Assemble the sensor to the metal valve stem using the screw (make sure the correct grommet size is on the metal
valve stem), then remove the cap, nut and washer from the metal valve stem.
(Fig 4) Insert the metal valve stem through the rim hole. Then place the back of the sensor body to face the inner surface
of the rim, so that the sensor is parallel to the rim.
(Fig 5) Holding the sensor in place, guide the washer onto the metal valve stem on the outside of the rim hole. Then secure
the nut on the metal valve stem and tighten to 2.95 Ft-lbs (4 N-m) torque. Once secured, affix the cap to the metal
valve stem.
(Fig 6) Secure the sensor to the metal valve stem by tightening the screw to 1.48 Ft-lbs (2N-m) torque.
Now remount the tire back onto the wheel, being careful not to damage the tire pressure sensor during mounting of the
tire.Lastly, balance the wheel as you would normally, adding weights if necessary to achieve rotational balance.
