TurfEx TS-50, Руководство пользователя и инструкции по установке

Страница: 8 / 16

Lit. No. 76736, Rev. 00 8 July 1, 2020
ASSEMBLY INSTRUCTIONS
Tires are not fully in fl ated when shipped. In fl ate tires
with a manual pump.
Attach the Wheels
1. Remove the spreader and parts from the carton
and arrange on the fl oor.
2. Remove and discard the insert plugs from each
side of the axle shaft.
3. Insert the axle through the axle hole in the lower
handle, then through the gearbox, and through the
lower handle on the other side of the spreader as
shown.
NOTE: Align the notches on the bearing and the
lower handle. Bearings must go through
fl at side
of lower handle (from the outside to the inside).
ASSEMBLY
WARNING
Use safety glasses and gloves when in fl ating
and installing the tires. Use manual pump
only to in
fl ate. Refer to the tire sidewall for
manufacturer's recommended pressure. Do
not exceed the maximum in
fl ation pressure.
4. Slide the axle bushing over the axle and into the
axle bearing on both sides as shown.
5. Install the drive wheel onto the axle. Align with the
hole nearest to lower handles as shown. Insert the
2" cotter pin through the drive wheel and through
the axle. Bend the cotter pin with pliers to prevent
it from falling out.
6. Install the coast wheel onto the axle, then using
the outside cotter pin hole, insert the 1" cotter pin
through the axle (not through the wheel). Bend
the cotter pin with pliers to prevent it from falling
out.
7. Turn the spreader over and onto the wheels.
Bushing
Bushing
Install the axle
as shown above.
Axle
Gearbox
Coast Wheel Side
1" Cotter Pin
Drive Wheel Side
2" Cotter Pin
Axle Bearing
Flat
Side
Notch
Lower Handle
Notch