Page 8 of 20
Turbovex A/S
Industrivej 45, DK – 9600 Aars
Telefon: +45 96 98 14 62 – Fax: +45 98 96 42 24
e-mail:
–
www.turbovex.dk
Wire and wire tensioners are fitted in the four brackets
on the side of the unit. Tension is applied to the wires
between the supplied bracket mounted on purlins and
battens. The purpose of the wires is to adjust and
keep the unit in a vertical position.
The inlet ring is pushed onto the unit and secured
using self-tapping screws from both inside and
outside. Now proceed to complete the roofing.
The soft cover is pulled over the unit. Seal the edge
using silicone rubber. Use silicone rubber under the
vertical part of the cover and on the top of the edge to
secure a watertight joint.
When the cover is cut, please note you will need a
10 cm overlap with the overlying roof tile or ridge.
The hole in the cover is cut using the same template
used for cutting the hole in the roof.
The hole in the cover must be cut in a diameter
about 5 cm smaller than that of the template to
ensure a tight fit.
The soft cover is fastened using self-tapping screws
and needs to be no more than 15 mm inside the unit
to ensure ample space for the rotating parts in the
unit.
The filter holders are sealed with silicone rubber and
secured using self-tapping screws.
The top cone is screwed in place using M8 bolts.
Silicone grout
Min 10 cm overlap
Silicone
