Page 10 of 20
Turbovex A/S
Industrivej 45, DK – 9600 Aars
Telefon: +45 96 98 14 62 – Fax: +45 98 96 42 24
e-mail:
–
www.turbovex.dk
The unit, weighing about 200 kg is mounted in the
brackets so the studs fall into place in the saddle
brackets.
Place a bolt in the saddle brackets securing the studs
in place.
When installing the unit on a slant roof using special
brackets, ensure that the service hatch is faced away
from the ridge of the roof for better access.
The large electric control unit can be moved to a
different location if needed.
The filter holders are sealed using silicone rubber seal
and secured in place using self-tapping screws.
The top cone is secured with M8 bolts.
To place the
holes correct, make sure that the arrows on the
filterholder and the top cone are aligned.
Now you can mount the inlet ring or a bottom
extension. (see 4.6.0)
The intake ring is pushed over the two tubes in the unit and secured with self-tapping
screws from both the inside and outside. Now finish the roofing.
