Page 9 of 20
Turbovex A/S
Industrivej 45, DK – 9600 Aars
Telefon: +45 96 98 14 62 – Fax: +45 98 96 42 24
e-mail:
–
www.turbovex.dk
4.5.0 Installing the unit using special brackets
Perform measurements and determine the placement
of the unit and drill a small center hole vertically
through the roof. The wooden frame is aligned with
the center hole. Now cut a square hole and secure
the frame to the rafters
Use a template (see 4.3.0 template) and cut a hole in
the wooden frame and the rest of the roof.
One part of the soft cover is mounted on the frame
and the hole is cut out.
The other cover is fastened so it covers the top of the
roof
and goes min. 10 cm under the rooftop
or the
next rooftile.
The two special brackets are mounted and the angle is adjusted according to the incline of
the roof. The rods are placed as shown on the figure so the saddles of the brackets are
nearer to the ventilation unit. The holes are placed in intervals of 5 degrees, from 0 to 45
degrees.
700 mm
305 mm
45 degrees
0 degrees
Min. 10 cm overlap
Template
