Turbosol Beton Master, Руководство по эксплуатации и обслуживанию

Страница: 15 / 58

TRANSPORTATION AND HANDLING
4
561270 - IS19/07 - EN
15/58
4 - TRANSPORTATION AND HANDLING
4.1 TRANSPORTING THE MACHINE AS A VEHICLE TRAILER
Only machines with a frame equipped with vehicle towing gear are allowed to circulate on public roads.
Always respect the rules of the road when towing the machine.
The machine cannot be used for carrying loads of any kind, not even the removable accessories used for
its operation (pipes, fittings, gaskets, etc.).
What to do before towing the machine
- Make sure the diesel engine is switched off.
- Remove all pipes and hoses connected to the machine.
- Close and fasten the casing and check the fasteners.
- Lower the towing wheel and raise the support legs (FIG. 06).
- Fasten the light bar in its towing position (FIG. 06).
1
4
2
5
1
3
FIG.06 FIG.07
- Check the efficiency of the drawbar, the hook on the vehicle and the coupling mechanism.
- Remove the safety pin (FIG. 07-REF. 1)
- Unscrew the handle (FIG. 07-REF. 2) completely.
- Pull the "stickers" off the side discs (with a strong upward pull, to the left and to the right). Use only the handle (FIG. 07-REF.
3) to adjust the height.
- The middle section can be adjusted upward by 50° and downward by 10° until it reaches the limit.
- Tighten and lock the handle.
- Insert the safety pin.
- Turn the lever to raise the towing wheel (FIG. 07-REF. 4).
- After approximately 50 km, stop and tighten the handle again.
- Connect the light bar cable and make sure it works.
- Insert the snap cable through the eyelet welded on the side (guide cable grommet) (FIG. 08-REF. 1) and fasten the snap hook
to the hole (FIG. 09).
Make sure the cable is long enough to handle bends in the road. If the cable is too short it might
accidentally pull the brake.