16 TURBOLOCK TL114
4.2 Main Installation
Step 1.
Use a screwdriver to extend the bolt.
The bolt must be EXTENDED prior to installing the lockset (Fig. 7)
.
Step 2.
Install the outside section:
a. Gently feed the power cable through diameter hole carefully over the latch. (Fig. 6)
b. Adjust the latch pin to HORIZONTAL position, then insert it into the center hole of the
latch.(Fig. 6)
Ensure the bolt is EXTENDED and latch pin is HORIZONTAL when installing
outside section.
Do NOT force the cable’s connector end through any part of the lock.
Damaging the connector may make the lock unusable.
Step 3.
Hold the outside section then continue the installation on inside section. If needed,
have someone to hold the outside section to help you complete the following steps.
Step 4.
Remove battery compartment cover. (Fig. 9) Then carefully connect the two power cables. (Fig. 10) Ensure the
connector is seated properly and firmly.
Step 5.
Adjust the thumb of inside section to VERTICAL position. (Fig. 8)
Step 6.
Assemble the inside section on door by aligning mounting holes on the latch and inside section.Ensure the latch pin is
HORIZONTAL when inserting it into inside section. Then secure the inside section on the door with mounting screws.
(Fig. 11)
Horizontal
Latch Pin
Fig. 6
Power Cable
Extended
Retracted
Fig. 7
Rotate 90 degrees
