14. Manufacturer warranty
The turbocut Jopp GmbH guarantees that your cattle stunning apparatuses are
free of material and manufacturing defects. This warranty applies with the
prerequisite that the device is properly used, handled, cared for and cleaned in
accordance with these operating instructions and that the technical unit is looked
after. This means that only original consumables, accessories and spare parts or
other products of equivalent quality are used with the cattle stunning apparatus.
This warranty encompasses repair or replacement of defective parts free-of-
charge throughout the complete service life of the device. Parts that are subject to
normal wear, for example the rubber buffer and the bolt spring are not covered by
this warranty.
Further claims are excluded insofar as this does not contravene any mandatory
national or international regulations. In particular, turbocut Jopp GmbH shall not
be liable for direct or indirect defects or consequences of defects, losses or costs
in conjunction with the use of the cattle stunning apparatus for any purpose
whatsoever. Implied assurance for the use or suitability for a particular purpose
is expressly excluded.
The cattle stunning apparatus and/or affected parts must be returned to the
manufacturer or their appointed representative for repair or replacement
immediately after discovery of a defect.
This warranty declaration encompasses all warranty obligations on the part of
turbocut Jopp GmbH for the Blitz cattle stunning apparatuses and replaces all
earlier or simultaneous declarations, written or verbal agreements with regard
to warranty services.
C.I.P. Test verification
The Blitz cattle stunning apparatuses from turbocut Jopp GmbH are type-
approved and system-tested. For this reason, the device is furnished with a PTB
approval number and is registered with the nominated authority under:
DE-17-MARLIV18-PTB01
With this, the turbocut Jopp GmbH guarantees the compliance of each cattle
stunning apparatus with the approved design style.
Impermissible defects discovered during use are to be reported to the
responsible manager of the approvals authority (PTB) as well as the office of the
permanent international commission (C.I.P.).
www.schussapparate.de ● www.messer-lochscheiben-shop.de Page 17
www.schussapparate.de
•
www.messer-lochscheiben-shop.de
Page
16
