Goats
Fig. 9
Horses
Fig. 10
Poultry
Fig. 11
www.schussapparate.de ● www.messer-lochscheiben-shop.de Page 13
9. Maintenance and care
The cattle stunning apparatus should be carefully cleaned after each use to remove
powder residue and prevent corrosion. In certain circumstances, this can result in
functional faults and damage. With all cleaning work, observe the corresponding
hazardous substances ordinance with regard to the labelling and instructions for
the materials used.
The maintenance and repair shall be carried out only by capable, authorised and
trained personnel! Use of original parts is always essential to ensure that the
safety of the device is maintained!
Procedure for maintenance and care
(observe sketches on page 2, fig. 1-4)
o
Use hand protection (in order to prevent contact reactions)
o
Unscrew headpiece in unloaded condition
o
Unscrew lock
o
Remove bolt spring (only with BK and KB models), rubber buffer and bolt
Carefully clean the interior walls of the sleeve, the bolt, the bore of the
intermediate piece, the exterior of the cattle stunning apparatus and all of the
other parts, with the brushes screwed onto the cleaning rod. Coarse deposits
and dirt should be wiped off beforehand with oil (e.g. Ballistol). Check the bolt
in particular for corrosion as rust will reduce the firing force and could result
in embrittlement or hairline cracks. If the bolt is corroded this must be
replaced.
The dried parts should be lightly oiled with machine oil. Keep the rubber
buffer free of oils. Check the rubber buffer and the bolt spring for damage
and wear.
With the Kleiner Blitz and Blitz Schlag models, the position of the
rubber buffers should be swapped after every cleaning in order to
guarantee the longest possible service life.
Re-insert the bolts, rubber
buffers and bolt springs in this order again and screw the lock flush against
the sleeve. The bolt must be at least 3 - 4 mm from the lock.
It is likewise
recommended that the headpiece is washed in cleaning oil without being
dismantled and then lightly oiled with machine oil.
Check the correct function of the device by feeding the cleaning rod provided
into the empty intermediate piece and pressing the bolt out against the force
of the spring (only with models BK and KB). The bolt must then protrude from
the bottom end of the device and must be fully retracted into it again when
the cleaning rod is withdrawn.
www.schussapparate.de ● www.messer-lochscheiben-shop.de Page 14
www.schussapparate.de
•
www.messer-lochscheiben-shop.de
Page
13
