Turbo Ace MATRIX
51
14SG, double tap “LNK”
scroll down to “Function” press “RTN”
scroll
down to channel 5
Change CTRL to “SB”.
(2)
Now you need to make sure when the SB Switch is flipped forward (away
from you) the switch will change the flight controller to “GPS Mode”. If the
Control Mode Switch (See FIGURE 4.2 bottom) slider is closer to “M” or “A”,
then the Control Mode Switch slider is in the wrong position. To bring the
slider closer to “GPS”, double tap “LNK”
scroll down to “REVERSE”
scroll down to Channel 5
tap “RTN” and reverse your Channel 5 setting to
“REV” (which is now set to your SB Switch setting). This change will bring
the Control Mode Switch slider closer to “GPS”.
(3)
Transmitter can be turn on and off to bind and re-bind, which will make fail
safe testing easier. To setup Fail-Safe, double tap “LNK”
scroll down to
“END POINT”
scroll down to Channel 5
adjust travel value until the
failsafe turn blue
double tap “LNK”
scroll down to “FAIL SAFE”
scroll
down to Channel 5
scroll to F/S and change to “F/S”
scroll to “POS” and
hold “RTN” for 1 sec, it will set the value for failsafe itself.
(4)
Move your SB Switch to the middle position to set the sub trim for the middle
position first. If the “A” segment turns blue please skip to Step #6.
(5)
If the “A” segment does not turn blue, double tap “LNK”
scroll down to
“SUB-TRIM”
scroll down to Channel 5
change the value until “A”
segment turns blue.
(6)
Flip the SB Switch forward (away from you). If the “GPS” segment turns blue
then skip to Step #8.
(7)
If the “GPS” segment does not turn blue, double tap “LNK”
scroll down to
“ENDPOINT”
scroll down to Channel 5
find the travel value and tap
“RTN”
value will flash and you can change the value until “GPS” segment
turns blue.
(8)
Flip the SB Switch backward (towards you). If the “M” segment turns blue
then skip to Section 4.2.11.
(9)
If the “M” segment does not turn blue, double tap “LNK”
scroll down to
“ENDPOINT”
scroll down to Channel 5
find the travel value and tap
“RTN”
value will flash and you can change the value until “M” segment
turns blue. Make sure to test the failsafe by turn off your transmitter and the
slider should move to failsafe and turn blue.
