FIG. 5
Maneuver the two
Guide Rods (#4)
into the holes on the
bottom side of the
Guide Rod Retainer (#5)
. Next, secure the
Guide
Rod Retainer (#5)
along with the two captive
Guide Rods (#4)
to the
Weight Stack Frame (#1)
using two Hex Head Cap Screws 1/2-13 X
3 1/4 (#27), four Flat Washers SAE 1/2” (#29), and two Nylon Insert
Lock Nuts 1/2-13 (#22).
FIG. 6
Locate the
Selector Pin w/Coil (#89)
and slide the ring over
the
Selector Bar (#8)
as shown above.
FIG. 7
Connect the
Cable (#49)
to the
Top Plate Selector Bar
(#8)
by threading the Finished Hex Nut 1/2-13 (#85) and inserting a
Split Lock Washer 1/2” (#82) to the Cable Hex Tap Bolt 1/2-13 X 3
(#84). Then, thread the Cable Hex Tap Bolt 1/2-13 X 3 (#84) to the
threaded socket of the
Top Plate Selector Bar (#8).
Loosely Fasten:
Do not completely fasten this hardware as-
sembly at this time, as it will be completely fastened later in
the assembly process.
Note:
Refer to
Fig A
on fold-out page 10 for further detailed il-
lustration of this assembly.
FIG. 8
Adhere the Decal Weight Numbers (#90) to the Weight
Plates (#7) in the corresponding order. Begin with the 20 at the top, 30
next, and so on.
3
5
1
4
4
89
8
8
89
84
85
82
8
49
90
7
90
7
SP-415 Inner/Outer Thigh
