18
PROPANE GAS TO NATURAL GAS
CONVERSION PROCEDURE FOR
AUTHORIZED INSTALLER
For alternative types of installation, contact your
nearest dealer.
•
Disconnect the gas supply and remove the
plate, grills, flare guards and burners from the
barbecue and the Wok burner if fitted.
•
Remove the main injectors and replace
them with the correct 1.7mm injectors for
each main burner. If a Wok burner is fitted
replace the Wok injector with the correct
size required for Natural Gas written on the
data plate.
•
Re-assemble the burners, flare guards, plate
and grills.
•
Replace the PROPANE GAS hose and
regulator with an approved natural gas
regulator and hose.
•
Turn the gas on and test for leaks, repair if
necessary.
•
Light 3 burners and turn them to high and set
the pressure at 1 KPA.
•
Now turn all the burners to the “LOW” setting
and check the flame pattern is steady, if
necessary you can adjust the low setting by
removing the gas control knobs and insert
the 2.4mm slotted screw driver supplied into
the valve shaft, the “low” setting can be
adjusted up or down to suit your gas pressure
by turning the screw driver.
•
Turn the screw driver anti-clockwise to adjust
the flame height up or turn it clockwise to
Turn it down.
NOTE:
you want to achieve the lowest flame
height at “LOW” but you don’t want to
adjust it too low as it could blow out on its
own or due to a breeze.
•
Check the operation of the ignition to the
burners and make any necessary adjust-
ment. Note Natural gas is lighter than air you
may need to adjust the ignition probe up a
little higher for it to light.
•
Ensure the data plate is changed / altered
to contain correct information i.e. remove
the old Gas type label and replace it with a
natural gas label and date of conversion.
