Tube-Line NITRO 950, Руководство оператора

Страница: 17 / 75

2-2
Section 2 - Operation -
Nitro 950
11. When unhooking from the tractor, reverse the
above procedure.
NOTE: Occasionally air may
become trapped in the hydraulic circuit, making it
necessary to “bleed” the circuit.
To perform this operation cycle the hydraulic
several times or especially on older tractors,
temporarily loosen an easily accessible hose
¿WWLQJHQRXJKWRDOORZDQ\WUDSSHGDLUWRHVFDSH
ZKLOHF\FOLQJWKHK\GUDXOLFV5HWLJKWHQ¿WWLQJ
Tractor Preparation
Follow this procedure when selecting and
preparing a tractor for use with the machine:
8VHRQO\DWUDFWRURIVXI¿FLHQWSRZHUDQG
weight to adequately handle the machine. It is
recommended that the tractor have at least 200
PTO horsepower for normal operating conditions.
(see PTO / Horsepower Requirements on
page
2-1 ).
2. It is recommended to pin the drawbar in its
centre draft position.
3. Use only a drawbar pin with provisions for a
mechanical retainer. Always install the retainer.
4. Always attach a safety chain between the
tractor and the machine to prevent unexpected
separation.
Spreader Preparation
Your new Nitro spreader has a brief breaking-
in period that you should follow for optimal
operation, and for maximum lifetime of your
SURGXFW:KHQXVLQJWKHPDFKLQHIRUWKH¿UVW
time, it is extremely important to follow all of the
procedures especially those listed in the “Before
using” section to avoid damage:
Before Use
1. Read the Nitro Operator’s Manual. Do not
operate the spreader until the safety precautions
in this manual and the decals on the spreader
have been read and understood by the operator.
2. Check for proper assembly and tighten all
bolts. All bolts were checked at the factory when
assembled but may need to be re-torqued as
vibrations in shipment may loosen them slightly.
3. Complete all steps in “Tractor Preparation &
Spreader Preparation” sections.
4. Lubricate the machine. Refer to the Service
section of this manual. Proper maintenance and
lubrication is the user’s responsibility and must
EHJLQEHIRUHWKH¿UVWXVH
5. Operate the machine slowly for a period of
WLPHWRUXQWKHFKDLQVLQDQGFRQ¿UPWKDWDOOSDUWV
work freely.
After Operating for 2 hours:
1. Check wheel bolts torque.
2. Check all shields and guards. Tighten as
required.
3. Visually inspect all hydraulic hoses and
couplers. See “Hydraulic Safety” in the Service &
Maintenance section of this manual.
4. Check chain tightness. See “Adjust Chain
Tension” in the Troubleshooting / Maintenance
section of this manual.
After Operating for 10 hours:
1. Repeat the 2 hour service list.