Tube-Line NITRO 950, Руководство оператора

Страница: 21 / 75

3-2
Section 3 - Transportation / Storage -
Nitro 950
Travel Speed
A suggested starting speed is between 4-5 mph.
This can be adjusted to operator preference.
WARNING: Normally, the load itself blocks ma-
nure and loose materials from being thrown
towards the front. As the load/pile gets reduced,
the rotation of the rear beaters can throw some
material forward, therefore it is strongly recom-
mended to lower the rear gate about 1/3 of the
way down to prevent debris from being projected
towards the front.
Unplugging
The following is a recommended procedure
that may help if the manure spreader becomes
plugged or the PTO disengages:
1. Disengage the hydraulics that run the apron
chain.
5HYHUVHWKHDSURQFKDLQE\ÀLSSLQJ\RXUWUDF
-
tor hydraulic lever.
3. Engage the hydraulics to reverse the apron
chain in order to back material away from beat-
ers. Stop apron chain after material is backed
away from beaters or if pile doesn’t move.
4. Engage the beaters. Bring beaters back up to
regular speed.
5. Follow the instructions in the Unloading sec-
tion (pg. 2-4) to start the apron chain in the stan-
dard operation direction.
If this above procedure does not solve the situ-
ation, closer inspection and possible manual
unplugging may be required. Make sure to stop
tractor and wait for all moving parts to stop before
servicing or unplugging:
WARNING: Stop tractor engine, place all controls
in neutral, set park brake, remove ignition key
and wait for all moving parts to stop before ser-
vicing, adjusting, repairing or unplugging.
Storage and Cleaning
Disconnect PTO drive shaft and hydraulic hoses
before cleaning, adjusting, lubricating, or servic-
ing this machine.
1. The spreader must be thoroughly cleaned
for extended storage. Manure is acidic and will
damage paint and cause rusting of metal compo-
nents.
2. Allow the spreader to completely unload.
3. To clean the spreader, raise the rear gate.
Warning: Turn off all power during cleaning
and inspection. Do not use power to move
any components or to discharge material
while cleaning or inspecting.
4. Hose off manure from the outside and inside
of the spreader. Completely clean manure from
moving mechanisms such as the beaters and
UHDUJDWH5HPRYHDFFXPXODWLRQLQFRQ¿QHGDU
-
eas or pockets that trap manure.
5. Avoid directing high pressure spray directly on
EHDULQJVVHDOVDQGÀRZFRQWUROYDOYH
6. Keep high pressure spray moving on painted
surfaces. Sustained spray on cracks or scratches
in paint can result in paint peeling.
7. Allow machine to dry.
8. Lower rear gate completely down before stor-
ing spreader.
9. Inspect the spreader for loose connections,
damaged hydraulic hoses or connections and for
other damaged components. Repair if necessary
so the spreader is ready for future operation. See
Hydraulic Safety on
page 4-1 .